常见问题

IEEE 802.3af-2003 PoE standard provides up to 15.4 W power on each port. It uses a minumum of 44vDC.

True. The graphics once selected, their position size and color are fixed. However not all controls need be present. Bselecting the check boxes for the parameters in the WM Touch, or by turning on the switches in the Views Designer the programmer can add the desired control parameters to the control scheme.

Yes. Any channel from any amplifier can be the member of a zone, but a member of only (1) zone. Amplifier channels can not be members of multiple Zones. Once an amplifier channel is assigned to a zone, it can no longer be assigned to be a part of any other zone.

Yes, the WM touch is a PoE network device and can be incoorperated in any standard network. The WM Touch is powered by standard PoE and can be connected with Category 5 or higher unsheilded cable.

Yes, however, all controls assigned to the passive controllers will be read-only in the WM Touch. In other words, if the level of a zone is controlled with a local WMP knob, it will not be possible to control this level from the WM Touch.

It is likely that the device firmware needs to be updated. Please check the Troubleshooting section in the product's User Guide for detailed instructions regarding the upgrade of firmware in the WM Touch.

A maximum lenght of 100 m (328 ft.) is recommended.

Category 5 or higher grade cable.

Yes. The IP Address can be configured to be static in ArmoníaPlus. This parameter is found under Config > IP.

Standard PoE. The IEEE 802.3af-2003 PoE standard provides up to 15.4 W power on each port.

Yes. This can be set from the Hidden Settings menu in the WM Touch. Check the product's User Guide section Local Configuration for more information.

Using the removal pin provided with the product, unclip the panel from the metal plate. Be very careful not to damage the Touchpanel. The metal plate is hooded onto integrated plastic tabs of the WMT Touch. The Tool is used to unhook the metal hooks from the plastic tabs.

Use a standard (1) Gang Electrical box. Low Voltage boxes are acceptable. The box should be mounted horizontally to support the Landscape orientation. The electircal box should be mounted vertically to support the Lortrait orientation.

Yes, a custom image can be loaded from ArmoníaPlus. You must use a 100 pixel X 100 pixel .png graphics file.

No. The layout uses fixed graphics with designated positions of appearance. Much time and thought went into the User Interface Engineering and Control System flow. This feature adds value as the integrator does not have to spend time creating custom graphics themes for the customer.

Yes, the commands for changing sources and zones can be generated by 3rd party control devices

No, there is no need for any computer connected to the system when WM Touch is running in the system.

Some configurations such as screen orientation and language can be set directly on the device. More advanced configurations will require ArmoníaPlus. Please refer to the product's Users Guide here for more information.

Yes, the WM Touch includes the Views Host for running controls on the Sys Control App and Web Views, so no additional hardware is needed

Yes, there is no restriction to the number of WM Touch panels used in a system

MEZZO is the perfect fit for WM Touch, however any DSP+Dante enable Powersoft product can be controlled

Yes, a screen unlocks passcode can be set.

No, the WM Touch has an embedded Views Host and can also be used to run the Sys Control App and Web Views

Input source selection per zone

Level and mute per zone

Scene Recall

System Power On/Off