常见问题

To activate the Energy Save mode on the Canali Series, the DIP Switches on the rear panel for Duecanali and Quattrocanali and on the front panel for Ottocanali Series must be used. The activation times are 4 seconds for Ottocanali and 30 Minutes for Duecanali and Quattrocanali Series. Through ArmoníaPlus you can change the activation time and the threshold for the input signal that will activate the energy save.

In the display go to page 10, hold the "cogwheel" key for 3 seconds and then choose the "LCD brightness" option. You can choose between: Dark, Normal, Bright.

Use Lantronix Device Installer and follow our Tech Note: M series IP Management and Recovery

X Series Red Light means a hardware fault. Reboot the amplifier and if the red light is still present contact Powers Service Center at service@powersoft.it

Just hold down the button in the rear panel for 3 seconds, the amplifier will send a signal to the speakers, it will make specific measurements and settings for each channel and after a few seconds the amplifier will be ready for use. Autosetup also can be triggered from ArmoníaPlus under "Autosetup" Tab in the workspace.

Yes, the amplifier is capable to work in mixed configuration without any problem. To protect loudspeaker be sure to have the right preset loaded or use the AutoSetup function.

Yes, MEZZO Series and Canali series (except for Ottocanali) amplifiers have a dedicated VCA input where a 10kOhms potentiometer can be connected.

Unfortunately not because they have different DSPs, to better understand these differences you can use ArmoníaPlus, adding the amplifiers in offline to understand what each DSP offers you.

Insert USB Key (FAT32) in the front panel an press together CH2 & CH3 buttons (on X4 / X4L) or CH 4 & CH 5 (on X8)