よくあるご質問
アンプ・プラットフォーム、ソフトウェア、システム設定に関する回答。
Network setting
7 件の質問How to reset the network in the T Series?
In the display go to page 9.1, hold down the "cogwheel button" for 3 seconds and then confirm the operation that will reset the network and report the amplifier to DHCP. If you want to also reset Dante Network of the amplifier just go to the next page 9.2 and do the same operation.
Is it possible to have control redundancy via ArmoníaPlus?
Unfortunately it is not possible to have the redundancy in the control but only the redundancy of Dante, in the X and Ottocanali Series.
How to reset the network in the Canali Series?
Remove front panel left mask (magnetic) and press the soft reset button for 3 sec.
How to reset the network in the X Series?
Press together Wi-Fi button and Callback Button until front panels leds start flashing green. Release the buttons and wait the amplifier reboot itself.
I can't discover my amplifier in ArmoníaPlus
Enable the network card in the communication manager of A+. If the problem persist do a network reset of the device.
How to update the K Series firmware?
To update the K Series firmware, you must contact the distributor or Service Center nearest you. Specifying the model, and current amplifier firmware.
Do I need to connect the amplifier to a DHCP server to control it?
No, DHCP server is not required. If you don't have a DHCP server the amplifier will automatically take the IP address 169.254.xxx.xxx.