Ottocanali 8K4 DSP+D 提供冗余的通用开关模式电源，应用了功率因数校正（PFC）和专利技术智能轨道管理（SRM），最大程度提高了产品的可靠性和效率，降低了功耗。 全新的 Ottocanali 8K4 DSP + D 代表了信号处理的创新水平，提供了非布尔值的路由和混合，带有升余弦、IIR 和 FIR滤波器的多级均衡，输入处理中的可调延时高达 2 s + 100 ms（输出）用于时间对准，增益和极性调整，分频器，峰值限制器，TruePower™限制器和主动阻尼控制 Active DampingControl™。 Powersoft传奇的高效性节省了宝贵的能量，最大程度降低了运行成本以及碳排放：Ottocanali 8K4 DSP+D 具备出众的低功耗和热耗散；这大大降低了交流电源和空调/冷却系统的成本 – 更不必说给环境带来的好处。 此产品提供MyPowersoft服务 电源 冗余的通用开关模式电源，最高可承受400VAC 交流电，带功率因数校正 专利输出滤波器，带波纹消除网络 低浪涌限制减少了交流电浪涌电流，无需额外购买昂贵的电源时序器 可拆卸交流电源线缆，带 IEC C19/22. 2 插座（16A 适用于欧洲，20A 适用于美国） 保护 全面的保护电路： 交流保护：当交流电源电压超出操作范围时，关闭电源 削波限幅器：防止严重削波的波形到达扬声器，同时维持全峰值电源输出功率 直流保护：防止输出端出现次声信号 甚高频保护：防止无法被听到的强烈非音乐高频信号到达扬声器 短路保护：自动保护重置功能防止功放发生短路，或输出电路发生其它应激故障 Long term 限幅器：保护扬声器免受稳定的长期RMS(非音频)信号减少最大输出 热保护：输出级操作温度最高为 80 °C (176 °F) 温控连续变速风扇，从前到后气流冷却/li> 常规 固定频率开关模式输出级，实现高品质声音精度 所有型号为2RU，节省了机架成本和空间 重量轻 – 方便机架安装和装运：14 kg （30. 8磅） 标准凤凰接头：用于模拟和数字输入、音频输出、辅助供电、警报器和通用输入输出 每格通道都有可用远程开关控制的双输入（主输入和辅助输入） 扬声器系统配置 直接驱动低阻抗负载或 70V/100V 高阻分布式线路 每个通道有可用开关切换的 35Hz/70Hz 高通滤波器 可以与低阻和高阻系统混合配置 低阻模式通道可桥接 数字信号处理 TI C6000 DSP 平台架构 AD / DA 转换器：双 24bit @96 kHz Tandem®架构，每通道 127 dB动态范围 每个通道独立的输入/输出均衡器，提供升余弦、自定义FIR 和参数 IIR：峰值、高/低搁架、全通、带通、带阻、高/低通 分频器：线性相位（FIR
为不间断运行而设计
Powersoft’s DSP implements a complete audio management system that provides a unique level of control and can be used to set the tone of any space.
Our current line of amplifier offers Dante™ either as standard or as an option on any model, for audio over IP networking.
Powersoft has always been very focused on energy saving and the use of the Power Factor Correction (PFC) has been a trademark for improving performance and containing mains current draw and consumption.
In any amplifier output stage, the efficiency is a function of the difference in the output voltage delivered to the load and the rails voltage delivered from the power supply.
Power Sharing enables part of the power to be shared across all output channels so that it can be used where it is needed the most.
With modern systems growing larger in size, the resistance that is added by lengthy cable runs starts to become an issue.
Ottocanali系列 - all models
| Model | Total power | Per channel | Channels | Form factor | AoIP |
|---|---|---|---|---|---|
| OTTOCANALI 12K4 DSP+D | 12000 W | 1000 W @ 2 Ω 1500 W @ 4 Ω 850 W @ 8 Ω | 8 | - | Dante / AES67 |
| OTTOCANALI 12K4 | 12000 W | 1000 W @ 2 Ω 1500 W @ 4 Ω 850 W @ 8 Ω | 8 | - | - |
| OTTOCANALI 8K4 DSP+D | 8000 W | 850 W @ 2 Ω 1000 W @ 4 Ω 600 W @ 8 Ω | 8 | - | Dante / AES67 |
| OTTOCANALI 8K4 | 8000 W | 850 W @ 2 Ω 1000 W @ 4 Ω 600 W @ 8 Ω | 8 | - | - |
| OTTOCANALI 4K4 DSP+D | 4000 W | 450 W @ 2 Ω 500 W @ 4 Ω 250 W @ 8 Ω | 8 | - | Dante / AES67 |
| OTTOCANALI 4K4 | 4000 W | 450 W @ 2 Ω 500 W @ 4 Ω 250 W @ 8 Ω | 8 | - | - |
特点
- Universal switch mode power supply up to 400V AC tolerant with Power Factor Correction
- Patented output filter with ripple cancellation network
- Low Inrush Limiting reduces AC inrush current, removing the need for expensive power sequencers
- Detachable AC mains cable with IEC C19/22.2 (16A for EU, 20 A for USA) socket
- Ac protection: shut down power supply when AC mains voltage is outside operating range
- Clip limiter: prevents severely clipped waveforms from reaching loudspeakers, while still maintaining full peak power output
- DC protection: protects against infrasonic signal at the outputs
- VHF protections: protects the loudspeakers against non audible, strong, non musical high frequency signals
- Short circuit protection: protects the amplifier from short circuit or other stressful events for the output circuits with automatic protection reset
- Long term limiter: protects the loudspeaker against steady long term RMS (non audio) signals, by reducing maximum output
- Thermal protection: output stages operating temperature up to 80 °C (176 °F)
- Temperature controlled continuous variable speed fan, front to back airflow
- Fixed frequency switch mode output stage for high grade sound accuracy
- All models 2 RU for reduced rack cost and space
- Light weight - for easier racking and shipping: 14 kg / 30.8 lbs
- Standard Phoenix connectors: analog and digital input, audio outputs, aux supply, alarms and GPIO
- Remotely switchable double input
- Direct drive either low impedance loads or 70V / 100V Hi-Z distributed lines
- Switchable 35Hz / 70Hz high pass filter per channel
- Mixed configuration with Lo-Z/Hi-Z systems possible
- Bridged mode, with low impedance, per channel pair
- TI C6000 DSP platform architecture
- AD/DA converter: dual 24bit @ 96 kHz Tandem® architecture, 127 dB dynamic range, per channel
- Input/output independent equalizers per channel providing Raised-cosine, custom FIR, parametric IIR: peaking, hi/lo-shelving, all-pass, band-pass, band-stop, hi/lo-pass
- Crossovers: linear phase (FIR), hybrid (FIR-IIR), Butterworth, Linkwitz-Riley, Bessel: 6 dB/oct to 48 dB/oct (IIR)
- Input delay up to 2s and output delay up to 100ms for time alignment per channel
- Active DampingControl™ for cable compensation
- Power limiter (TruePower™, RMS voltage, RMS current) + Peak Limiter
- NC/NO contacts per channel for alarm notifications
- Remote ON/OFF switch
- Remote AUX/MAIN inputs switch
- PWS OUT connector providing 24VDC
- Control and monitoring through ArmoníaPlus
规格
| Output power per Channel | |||
|---|---|---|---|
| Output power per Channel | 850 W @ 2 Ω | 1000 W @ 4 Ω | 600 W @ 8 Ω |
| Bridge mode | 1700 W @ 4 Ω | 2000 W @ 8 Ω | |
| Max output voltage / current | |||
| Single channel mode | 90 Vpeak / 23 Apeak | ||
| AC main power | |||
| Power supply | Universal, regulated switch mode witd PFC (Power Factor Correction) | ||
| Nominal power requirement | 100-240 V ±10%, 50-60 Hz | ||
| Operating voltage | 90 V - 264 V | ||
| Power consumption/current draw | |||
| Idle | 115 V: 74 W - 0.85 A | 230 V: 77 W - 0.75 A | |
| 1/8 of max output power @ 4 Ω | 115 V: 1425 W - 12.6 A | 230 V: 1425 W - 6.6 A | |
| THERMAL | |||
| Operating temperature range | 0° - 35° C - 32° - 95° F | ||
| Thermal dissipation* | |||
| Idle | 115 V: 253 BTU/h - 64 kcal/h | 230 V: 263 BTU/h - 66 kcal/h | |
| 1/8 of max output power @ 4 Ω | 115 V: 1480 BTU/h - 373.0 kcal/h | 230 V: 1504 BTU/h - 379.0 kcal/h | |
| 1/4 of max output power @ 4 Ω | 115 V: 2792 BTU/h - 703.6 kcal/h | 230 V: 2722 BTU/h - 685.9 kcal/h | |
