此产品提供MyPowersoft服务 电源 通用开关模式电源，最高可承受 400VAC 交流电，带功率因数校正 专利输出滤波器，带波纹消除网络 低浪涌限制减少了交流电浪涌电流，无需额外购买昂贵的电源时序器 可拆卸交流电源线缆，带 IEC C19/22. 2 插座（16A 适用于欧洲，20A 适用于美国） 保护 全面的保护电路： 交流保护：当交流电源电压超出操作范围时，关闭电源 削波限幅器：防止严重削波的波形到达扬声器，同时维持全峰值电源输出功率 直流保护：防止输出端出现次声信号 甚高频保护：防止无法被听见的强烈非音乐高频信号到达扬声器 短路保护：自动保护重置功能防止功放发生短路，或输出电路发生其它应激故障 Long term 限幅器：保护扬声器免受稳定的长期RMS(非音频)信号减少最大输出 热保护：输出级操作温度最高为 80 °C (176 °F) 温控连续变速风扇，从前到后气流冷却 常规 固定频率开关模式输出级，实现高品质声音精度 尺寸紧凑，所有型号为1RU，节省了机架成本间 重量轻 – 方便机架安装和装运：5-11 kg（11-24. 3磅）取决于 BatFormers 的数量 标准凤凰接头：模拟和数字输入，音频输出，辅助供电，警报器和通用输入输出 每个通道都有可用远程开关控制的双输入（主输入和辅助输入） 扬声器系统配置 直接驱动低阻抗负载或 70V/100V 高阻分布式线路 每个通道有可用开关切换的 35Hz/70Hz 高通滤波器 每通道内置可关闭的削波限幅器 可以与低阻和高阻系统混合配置 低阻模式通道可桥接 警报器和通用输入输出 通用输入输出警报界面: 输出型号中存在危险的直流电 热应力 每个通道可配置的常开常闭警报触点 远程辅助输入/主输入切换开关 远程开关 PWS 输出接口最高可提供 24V 直流 数字信号处理 Analog Devices® ADAU 1702 DSP 架构 AD / DA 转换器：双 24bit @48kHz Tandem® 架构，每通道 100dB 动态范围 每个通道独立的输入/输出均衡器，提供参数均衡，搁架IIR滤波器 可调延时高达 16ms 用于时间对准 主动阻尼控制™，用于线径补偿 峰值限制器+功率（RMS）限制器 远程管理 通用 ArmoníaPlus 进行控制和监控 带 MediaMatrix, Crestron, AMX, Q-SYS 监控系统界面 General Output power per channel Output power per channel 150 W @ 4 Ω 80 W @ 8 Ω Bridge mode 300 W @ 8 Ω 150 W @ 16 Ω Max output voltage
Ottocanali系列 1204 - all models
| Model | Total power | Per channel | Channels | Form factor | AoIP |
|---|---|---|---|---|---|
| OTTOCANALI 1204 系列 | 1200 W | 150 W @ 4 Ω 80 W @ 8 Ω | 8 | 1 RU | - |
| OTTOCANALI 1204 DSP | 1200 W | 150 W @ 4 Ω 80 W @ 8 Ω | 8 | 1 RU | - |
特点
- Universal switch mode power supply up to 400VAC tolerant with Power Factor Correction
- Patented output filter with ripple cancellation network
- Low Inrush Limiting reduces AC inrush current, removing the need for expensive power sequencers
- Detachable AC mains cable with IEC C19/22.2 (16A for EU, 20 A for USA) socket
- Ac protection: shut down power supply when AC mains voltage is outside operating range
- Clip limiter: prevents severely clipped waveforms from reaching loudspeakers, while still maintaining full peak power output
- DC protection: protects against infrasonic signal at the outputs
- VHF protections: protects the loudspeakers against non audible, strong, non musical high frequency signals
- Short circuit protection: protects the amplifier from short circuit or other stressful events for the output circuits with automatic protection reset
- Long term limiter: protects the loudspeaker against steady long term RMS (non audio) signals, by reducing maximum output
- Thermal protection: output stages operating temperature up to 80 °C (176 °F)
- Temperature controlled continous variable speed fan, front to back airflow
- Fixed frequency switchmode output stage for high-grade sound accuracy
- Compact 1 RU for reduced rack cost and space
- Lightweight - for easier racking and shipping: 5-11 kg (11-24.3 lbs) depending on the number of BatFormers
- Standard Phoenix connectors: analog and digital input, audio outputs, aux supply, alarms, and GPIO
- Remotely switchable inputs (main and aux) per channel
- Direct drive either low impedance loads or 70V / 100V Hi-Z distributed lines
- Switchable 35Hz / 70Hz high pass filter per channel
- Built-in defeatable clip limiters for each channel
- Mixed configuration with Lo-Z/Hi-Z systems is possible
- Bridged mode low impedance per channel pair
- General Purpose Input/Output alarm interfaces dangerous DC in the output power signal
- thermal stress
- Configurable alarm contact NC/NO per channel
- Remote AUX input / MAIN input switch
- Remote ON/OFF switch
- PWS OUT connector providing up to 24VDC
- Analog Devices® ADAU 1702 DSP architecture
- AD/DA converter: dual 24bit @ 48 kHz Tandem® architecture, 100 dB dynamic range, per channel
- Input/output independent equalizers per channel providing PEQ, shelving IIR filters
- Delay up to 16 ms for time alignment
- Active DampingControl™ for cable compensation
- Peak and RMS limiters
- Control and monitoring through ArmoníaPlus
- Interface available for MediaMatrix, Crestron, AMX, Q-SYS, and monitoring systems
规格
| Output power per channel | ||
|---|---|---|
| Output power per channel | 150 W @ 4 Ω | 80 W @ 8 Ω |
| Bridge mode | 300 W @ 8 Ω | 150 W @ 16 Ω |
| Max output voltage / current | ||
| Max unclipped output voltage @8 Ω | 37 Vpeak | |
| Current | 15 Apeak | |
| AC main power | ||
| Power supply | Universal, regulated switch mode with PFC (Power Factor Correction) | |
| Nominal power requirement | 100-240 V ±10%, 50-60 Hz | |
| Operating voltage | 90 V - 264 V | |
| Power consumption/current draw | ||
| Idle | 115 V: 20 W - 0.33 A | 230 V: 21.2 W - 0.36 A |
| 1/8 of max output power @ 4 Ω | 115 V: 224 W - 1.99 A | 230 V: 223 W - 1.24 A |
| 1/4 of max output power @ 4 Ω | 115 V: 423 W - 3.70 A | 230 V: 417 W - 2.00 A |
| THERMAL | ||
| Operating temperature range | 0° - 35° C - 32° - 95° F | |
| Thermal dissipation* | ||
| Idle Energy save ON | 115 V: 29.66 BTU/h - 7.48 kcal/h | 230 V: 31.71 BTU/h - 8 kcal/h |
| 1/8 of max output power @ 4 Ω | 115 V: 252.34 BTU/h -63.64 kcal/h | 230 V: 248.93 BTU/h - 62.78 kcal/h |
| 1/4 of max output power @ 4 Ω | 115 V: 419.41 BTU/h -105.78 kcal/h | 230 V: 398.97 BTU/h -100.62 kcal/h |
