I would like to place the IN interface for DSP-D in another side than our own heat-sink, created on purpose. What are the Pin-Outs from the Input interface > Ribbon > DSP-D?

From input interface come two flat cable, one of these is splitted in two different micro-match connectors. So here below you find the correspondence between the DIL connectors on the input interface and the Micro-Match connectors on the DSP-D.

CN1000 DIL Connector (on inptu interface) -> CN2 MicroMatch connector (on DSP-D)

CN1004 DIL Connector (on input interface) -> CN3 (pin 1 – 12) + CN1 (pin 13 – 26) MicroMatch connector (on DSP-D)